Concept renders. Each finished piece shows its own grain, so yours will differ a little.
Wall sconce
Wollemi
A linen shade held off a timber backplate by a single block arm.
$640 including GST
Delivered across Australia. [PLACEHOLDER: shipping rates and timing to confirm.]
About Wollemi
Named for Wollemi National Park, NSW
Wollemi is three pieces of timber and a linen shade: a tall backplate, a short block arm and a turned spigot. The shade sits close to the wall so the light washes down it in a gentle fan, and the timber glows where the light catches its edge. Fitted in pairs, it suits a bedhead or a hallway.
Because every Wollemi is made to order in the timber you choose, no two are quite the same. The grain, figure and colour are the tree's own, so expect some natural variation from the photos.
Specifications
- Dimensions
- 300 mm high, 200 mm wide, 220 mm deep
- Materials
- Timber backplate and arm, oil finish; natural linen shade
- Light source
- E14 LED globe included
- Output
- 470 lumens
- Colour temperature
- 2700K
- CRI
- 90+
- Dimming
- Trailing-edge dimmer
- Mounting
- Hard-wired, standard wall box
- IP rating
- IP20, indoor use
- Lead time
- Made to order, 4 to 6 weeks
All specifications are placeholders until tested and confirmed.
Downloads
- Spec sheet (PDF) [PLACEHOLDER]
- Install guide (PDF) [PLACEHOLDER]
Care
Dust with a soft dry cloth. Keep out of direct sun and away from heaters so the timber stays stable. A light coat of hardwax oil every few years brings back the sheen. Hard-wired lights must be installed by a licensed electrician.
